VELOX building ties

Structure of fixing ties with welded crossbars.

They ensure fixation of board position in outside and inside casing of walls, also serving to lay and join of each casing board on each other in vertical position of both coating.

• Produced from tow wire and made of steel 11 343, Velox building ties have a diameter of between 4 and 5 mm, including welding. They fulfil the required strength in tow 540 MPa

• Standard surface treatment is applied under the plaster

• The width of the ties vary and depends on the combination of each layer of a wall

• When used without plaster, it is possible to paint the surface with a special treatment

Available ties according to shape and usage:

One side ties - Usually laid in the bottom level of the first layer of casing, at ceiling level, on the inside of supporting walls and when windowsills are built.

Both-side ties - Placed frequently when laying and tieing each board of wall.

Ceiling ties - Placed on the same level as ceiling, the ceiling tie is laid on the peripheral, supporting wall with one end of the tie on inside the casing and the other one on the already drilled holes of connecting boards where it is fixed, with nails, on the end eye.

Tow ties - Run through pre-drilled holes in the center of the end eye of the outside boards and inside boards of casing. The end eye is fixed with nails. When using VELOX WS boards, it is recommended that you use 2 or 3 rows of casing boards so that the strength of the casing will increase during the concreting of the whole floor.

The better the building block, the better the building

Velox ICF forms are high-tech industry-leading insulated concrete forms that have proven technologies to make building easier and faster.

The Velox line of ICFs offer innovation that is exclusive to Velox, which allows builders the ability to build and design structures with greater efficiency.